Range Rover Classic

A fitting kit for front shock absorbers, includes upper and lower bushes, special washers and nyloc nuts for one shock absorber. SUITABLE FOR THE FOLLOWING LAND ROVER MODELS:Defender 90/110, 1983-2016Discovery 1, 1989-1998Range Rover Classic, 1983-1995

A replacement brass bleed plug that fits the thermostat housing and radiator bleed screw hole, much tougher than the original black plastic plug. Comes complete with new rubber O-ring. It can also be used to replace the plastic filler level plugs on the...

On later Discovery 1 and all Discovery 2 and Range Rover P38 models, Land Rover fitted a rubber coupling or 'doughnut' to the rear propshaft instead of a traditional universal joint. This rubber coupling was used to reduce noise and vibration; however,...

A complete automatic gearbox service kit for your Range Rover Classic automatic, with a replacement gearbox filter, seals and ATF fluid for 4-speed ZF automatic transmissions. Often neglected, automatic transmissions benefit from regular fluid and...

A quality replacement steering box drop arm complete with ball joint for right-hand drive cars. Fits all 4-bolt steering boxes. EQUIVALENT TO LAND ROVER PART NUMBER(S): QFW000020, RTC6396, STC1044, NTC2194 SUITABLE FOR THE FOLLOWING LAND ROVER MODELS:...

A pack of 8 special bolts and nyloc nuts for both ends of the rear propshaft. These are an unusual size bolt and usually end up getting chewed up when removing the propshaft. You must use the proper grade prop-shaft bolts for safety reasons, never use a...

When you use your Land Rover for work or expeditions, the need to carry sufficient fuel, water, vehicle spares and safety equipment invariably means that your Land Rover will be fully loaded, placing a lot of strain on the suspension components. Combine...

A pack of 8 special bolts and nyloc nuts for both ends of the front propshaft. These are an unusual size bolt and usually end up getting chewed up when removing the propshaft. You must use the proper grade prop-shaft bolts for safety reasons, never...

Defender bonnet prop clip but can also be used is a variety of applications for: Defender Range Rover Classic Discovery 1

A single galvanised lower coil spring seat for where the coil spring mounts to the axle. Galvanised for corrosion resistance, will not rust like standard parts. Note - Fits front and rear of 90 but front only on 110/130 models. Equivalent to Land Rover...

These galvanised rear spring seats come complete with retaining plates, bolts, nuts and washers. They are made to replace the existing standard seats if you're after a longer lasting version. KIT CONTENTS: 2 x Rear galvanised spring seats 2 x...

One of the significant factors limiting the rear suspension movement on vehicles fitted with an A-frame is the standard ball joint. This high articulation ball joint has been developed to provide significantly more articulation than the standard and...