Defender

A brand new, quality replacement air mass meter or airflow sensor. Air mass meters are fitted to the air intake system, just after the air filter. They measure the amount of air entering the engine, the ECU then uses this information along with data from...

Discovery 2 & Defender TD5 engine oil pump sprocket bolt SUITABLE FOR THE FOLLOWING LAND ROVER MODELS:Defender, Td5, 1998-2006Discovery 2, Td5, 1998-2004 EQUIVALENT TO LAND ROVER PART NUMBER(S): LYP101400

A special box spanner for use on the locking nuts that secure the wheel bearings in the hubs. The box spanner is a must have tool for any Land Rover owner, enabling you to easily remove the hubs and bearings or to adjust the wheel bearings. The box...

A replacement rear crankshaft seal. A quality OEM replacement part, equivalent to Land Rover part number: LUF100420 Suitable for the following Land Rover models:Defender, TD5, 1998-2006Discovery 2, TD5, 1998-2004

A pair of Bosch SuperPlus windscreen wiper blades. Suitable for all Defender models with the hook type wiper fitting right through to the very last 2016 Defender models. Suitable for the following models: Land Rover: Defender, All Models

Complete timing belt kit with Dayco timing belt. This is a modification kit so the included fitting guide must be adhered to when fitting, failure to install the components correctly can result in timing belt misalignment and premature failure. KIT...

Using these smart stainless steel replacement bolt and screw kits will prevent rust from spoiling your Defender's bodywork, ideal for smartening up your vehicle or a restoration project. Ideal for fixing Defender bonnet vents DA1974, DA1975, DA4000 &...

A new, MAHLE OEM branded engine oil filter. Equivalent to Land Rover part number: ERR3340 MAHLE part number OC261Suitable for the following models: Land Rover: Defender, 2.5 Petrol, 2.5D, 2.5TD, 2.5 200TDi, 2.5 300TDi, V8, 1983-1998 Land Rover: ...

Replace those rusty worn-out door hinges with this new set of 3 galvanised rear-end door hinges with stainless steel fittings. KIT CONTAINS: 3 x galvanised door hinges Stainless steel fitting kit PLACEMENT: Rear SUITABLE FOR THE FOLLOWING LAND ROVER...

A set of 3 grease-able track rod end ball joints 2 x RTC5869 with a RH thread and 1 x RTC5870 with a LH thread Most track rod ends are sealed for life but this can be a short life if you do any off-roading. A quick regular squirt of grease will ensure...

Smarten up your Defender with these Stainless Steel bulkhead vent hinge pins. Replaces the standard, often rusty hinge pins.Suitable for the following models: Land Rover: Defender, All models, Up To 2006

A replacement fuel injector harness complete with rocker cover gasket to make the job easier. The injector harness or loom is known as a wet loom. It is inside the top of the engine rocker cover, getting wet with the engine oil. It is common for the...